Here are some pics of the Heavy Lifter and the APC.
How they arrived in the bags:
Here is a close-up of the vehicles so you can get an idea of the details.
They look very "frosted over" because they are covered in plastic dust. I took the pictures just after I took them out of the bag and I had not had time to clean them off yet. (I did wash the Resizing Chambers in my previous posts so you can compare the two to see the level of "frosting" on the final product.)
I just received another notification from Shapeways on a print failure of the Heavy Lifter 3 pack. So I am pulling the 3 pack down and it will no longer be available. For whatever reason the single lifters print out just fine but when they are done in multiples then they break. There recommendation is to print it with in their constraints. Yet these models have to pass two checks to make sure it is with in their constraints. It appears these failures are happening post printing when they go to the cleaning process.